PIDR=0, ISEL=0, EOF=0, NCODR=0, DSCR=00, PODR=0, PDR=0, PCR=0, EOR=0, PMR=0, ASEL=0
P108 Pin Function Control Register
| PODR | Port Output Data 0 (0): Low output 1 (1): High output |
| PIDR | Port Input Data 0 (0): Low input 1 (1): High input |
| PDR | Port Direction 0 (0): Input (Functions as an input pin.) 1 (1): Output (Functions as an output pin.) |
| Reserved | This bit is read as 0. The write value should be 0. |
| PCR | Pull-up Control 0 (0): Disables an input pull-up. 1 (1): Enables an input pull-up. |
| Reserved | This bit is read as 0. The write value should be 0. |
| NCODR | N-Channel Open Drain Control 0 (0): CMOS output 1 (1): NMOS open-drain output |
| Reserved | These bits are read as 000. The write value should be 000. |
| DSCR | Drive Strength Control Register 0 (00): Normal drive output 1 (01): Middle drive output 2 (10): Setting prohibited 3 (11): High-drive output |
| EOR | Event on Rising 0 (0): Do not care 1 (1): Detect rising edge |
| EOF | Event on Falling 0 (0): Do not care 1 (1): Detect falling edge |
| ISEL | IRQ input enable 0 (0): Not used as IRQn input pin 1 (1): Used as IRQn input pin |
| ASEL | Analog Input enable 0 (0): Used other than as analog pin 1 (1): Used as analog pin |
| PMR | Port Mode Control 0 (0): Uses the pin as a general I/O pin. 1 (1): Uses the pin as an I/O port for peripheral functions. |
| Reserved | These bits are read as 0000000. The write value should be 0000000. |
| PSEL | Port Function Select These bits select the peripheral function. For individual pin functions, see the MPC table |
| Reserved | These bits are read as 000. The write value should be 000. |